Joint grouting osmotic grouting material

Product description:

Permeation grouting is the most common, and oldest form, of soil grouting. The technique

consists of drilling a hole in the soil, inserting an injection pipe into the ground and then pumping

any number of liquefied materials into the problem area. How the hole is drilled, type of injection

pipe, and what material is used, are all determined by the specifics of the repair being performed.

This type of grouting is typically limited to sandy soil conditions as this type of soil allows the grout

to permeate more readily over a wider area.Epoxy Sanding Floor,Epoxy Sanding Wear-resistant Floor,

Epoxy Sanding Anti-slip Floor.

Application area:

1, need high precision installation of equipment, equipment foundation of primary grouting
and secondary grouting.
2,Anchorage of steel bars and anchors in construction and geotechnical engineering.
3,Construction reinforcement and renovation project, Liang Zhu joint, deformation joint,
4,construction joint pouring.Road, bridge, tunnel, airport and OTHER engineering emergency repair use.
5,Anchorage construction of railway sleeper.Epoxy Orange Peel Floor.
6, column wet clad steel reinforcement used for filling angle and column gap joint.Concrete Curing Agent.

Product features:

1. The system of compensating shrinkage and gas expansion can compensate the shrinkage

and settlement of plastic slurry and ensure the close contact between grouting material and foundation.
2, no chloride-the formula does not use chlorides, thus avoiding the harm of chloride
3, free of iron-no stains due to rust or cracks due to expansion of rust
4, reliability-factory prepackaged material, which can eliminate the error caused by site mixing.

Solvent-free Color Sand Self-leveling,Solvent-free Colored Sand Floor.

Technical indicators:
test item	technical parameter
Compressive strength for 1 day)	≥15mpa
(28 days)	≥60mpa
New wet density	About 2150Kg/m3
Expansion time	About 2 hours
water permeability	≤2mm

Construction procedures:
1. The bottom plate must be clean, free of oil and other impurities, providing pressure relief

holes to ensure that all isolated places are ventilated
2. The cleaned foundation must be flooded with water a few hours before grouting. Remove

the free water and the water in the hole before pouring in
3, to achieve the required consistency, the amount of water must be accurate
4, stir until dispersed evenly, without caking,Antistatic Self-leveling Floor,Floor Coating Series.
5. After grouting is completed, all exposed areas should be maintained with curing agents or

wet sackcloth bags.

Contact us if you need more details on What is Cement Grouting. We are ready to answer your questions on packaging, logistics, certification or any other aspects about Concrete Grouting Contractors、Cement Injection Grouting. If these products fail to match your need, please contact us and we would like to provide relevant information.

Product Categories : Grouting Material